Your shopping cart is empty!
moppydrv Firmware Information
This firmware allows the ultimate in user customizability, with 16 built-in mode groups, that the user can select via a series of button presses and a user programmable turbo timer that will automatically step the power down to 50% after the set time is hit (see below for instructions).
Low voltage protection: The light will begin to step down output at around 3V under load. The light will not shut completely off, but will continue to run at a moonlight level.
User Selectable Groups:
MAIN GROUPS | [SPECIAL/DOUBLE CLICK ACCESS MODE]
- 100% Only
- 5% - 100% | [100%]
- 30% - 100% | [100%]
- 70% - 100% | [100%]
- 50% - 10% | [100%]
- 75% - 20% | [100%]
- Moon - 30% - 100% | [100%]
- 100% - 30% - Moon | [Strobe]
- Moon - 20% - 70% - 100% | [100%]
- 100% - 70% - 20% - 0% | [Strobe]
- Moon - 5% - 15% - 50% - 70% - 100% | [100%]
- 100% - 70% - 50% - 15% - 5% - Moon | [Strobe]
- 100% | [Strobe]
- Strobe | [100%]
- 100% | [Blink1]
- 5% - 33% - 100% - Blink1 - Blink 3 - Beacon | [Strobe]
moppydrv ​Instructions
Operation:
- A short tap switches the light on to the previously used mode, or off if the light is already on.
- A press & hold while the light is on cycles through the modes in the selected mode group.
- A press & hold while the light is off switches the light on in the first mode of the selected group.
- A double-click from either off or on puts the light into the special designated mode in that particular mode group.
To switch mode groups: rapidly tap the switch 8 times from either off or on. The light will then enter the programming mode and begin to flash, reading out the battery charge state. With the light in programming mode, tap the switch the same number of times as your desired mode group. The light will blink and your mode group will be memorized.
Example: To select mode group 3, tap the switch 8 times quickly to enter programming mode. When the light enters programming mode and beings flashing, tap the switch three times. The light will blink to recognize the mode group change.
To set the turbo timer: rapidly tap the switch 8 times. The light will then enter the programming mode and begin to flash. With the light in programming mode, tap the switch 20 times to enter the turbo timer set mode. The light will then switch to 100% power. When the light is at the desired temperature for the turbo step down, turn the light off. The turbo timer will then be set. The turbo timer steps the light down to 50% regardless of the mode group set. To disable the turbo timer, simply set the time to under 4 seconds.
Powered By Lumens
Mountain Electronics LLC © 2024
Mountain Electronics LLC © 2024