Your shopping cart is empty!
Convoy S2+ Flashlight Host - Sand / Desert Tan
Price: $15.49
Qty:
- OR -
Add to Wish List
Add to Compare
Add to Compare
This host features low-key matte sand / desert tan anodizing along with a smooth reflector for increased throw. As an added bonus, a deep carry clip is also included with this host.
For a single emitter build, just add a 16mm MCPCB+LED (Nichia 219C / Cree XP series preferred) and 17mm driver.
To build a triple LED flashlight, you will need to add the following components:
- 17mm Driver
- If you are running more than a 3.4A driver, you must bypass the tailcap switch spring using either copper braid or thin 22AWG / 24AWG silicone wire.
- (3) LEDs on a 20mm 3XP MCPCB
- Aluminum or Copper Spacer
- You will have to drill and chamfer a small hole in the brass pill to allow the wires to pass through.
- Aluminum is less expensive and lighter weight, while copper offers a small thermal advantage.
- Carclo 105xx Optic
- Thermal Compound
This host works with protected cells, including the Protected NCR18650B and Protected NCR18650GA.
Specifications:
- Reflector Finish: Smooth
- Reverse-clicky Switch
- Uses 1x 18650 battery
- Driver Diameter: 17mm
- MCPCB Diameter: 16mm
- Includes Lanyard
- Includes Deep Carry Clip
- If the deep carry clip is installed, it will scratch the finish of the light. Do not install this clip on any light until you are 100% sure you are going to keep it.
- Includes XP Reflector Centering Ring
- Diameter: 24mm
- Length: 119mm
- Weight: 88g
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
Powered By Lumens
Mountain Electronics LLC © 2024
Mountain Electronics LLC © 2024